Jewellery Services

SERVICES WE OFFER

We have a fully-equipped jewellery workshop run by our head goldsmith who has over 30 years experience and has worked for highly renowned jewellers. Skilled in all areas of jewellery repairs, from simple chain repairs to total redesign and manufacture. 

Below are approximate starting prices for our repairs:

 Silver Chain Repair from £10.00

 Gold Chain Repair from £18.00

 Silver Ring Resizing from £10.00

 Gold Ring Resizing from £25.00

 Clasps for Necklaces from £10.00

 Rethreading Beads & Charms from £15.00

 Clean & Polish from £10.00

 Rhodium Plating (to avoid tarnishing) from £18.00

 Deep Clean for Charm Bracelets from £15.00

For a more accurate quotation on any specific work that you require you can contact: ralph@graceandcojewellery.co.uk or you can use our Contact Form.

 

RING RE-SIZING

Here at Grace & Co we offer a full ring re-sizing service. We are able to offer a service for silver, 9ct, 18ct, yellow and white gold and even platinum rings.

The process starts by us checking the ring fully all over to make sure that all is well and there is no other damage to the ring or if there are stones set into the ring that the settings are all fine.

We then, what we call anneal the ring to soften the metal and to show up if there are any other joins in the shank of the ring or other solder points.

When the ring has cooled we cut the shank through and remove the correct amount of metal, if we are sizing down, or smooth each edge of the break to re-join or cut through ready to measure the correct amount of metal we need to size up the ring.

When sizing up a ring we use a dovetail style system for the original shank and the piece added so that we have the maximum area for soldering to give the best join that we can get.

Once the ring has been soldered and cooled down, the item is dipped in acid to remove any remaining fluxes or discolouration.  The area of repair is then smoothed using files and fine emery paper ready for the polishing process.

 

CHAIN REPAIRS

We are able to offer a service to repair precious metal chains and bracelets.

The process starts by checking the item all over to find out if there are any other areas that may need attention.

The area that needs attention is soldered and cleaned ready for polishing.

If it is a new catch that is required, we will source the nearest match to the original that we can and replace it as necessary, and clean up ready for polishing.

 

STONES, SETTINGS & CLAW

If your item comes to us with a stone that has fallen out, and you have the stone, we will check to see if the stone is ok, and, if ok we will check the settings where the stone is placed to make sure that all the claws or other settings are intact. If all is well then we will reset the stone, and send to the polishing department.

If the stone has fallen and been lost or has broken we will obtain stones to match and then follow the steps above.

You may also find that sometimes the claws may break or become sharp on your settings, these can be rectified by either replacing the claw in question or smoothing the claw that is in place.

There are some items that we may request a customer’s own risk signature.

These include items with fragile stones, such as emerald and pearls, or jobs where it is best to remove stones to complete the job.

 

POLISHING

When the items arrive in our polishing department, the items are first checked to make sure all the work has been completed and the items are finished properly. They then go through a two-stage polishing and three-stage cleaning process before drying and cleaning by hand.

For a more accurate quotation on any specific work that you require you can contact: ralph@graceandcojewellery.co.uk or you can use our Contact Form.

Top